Pre-Installation Information

IMPORTANT WARNINGS

Be sure that the existing electrical system prior to installation conforms to all local codes and ordinances.

The electrician may need to consult the local building inspector regarding code compliance prior to install-ing the waterfall unit and controller.

Before attempting to install, ensure that all power to the electrical circuit supplying power to the system has been disconnected or turned off at the circuit breaker.

Do NOT stand on, drop, or step on the waterfall.

Use only water that has been properly filtered by an in-line cartridge filter. Failure to properly filter water running to the waterfall may result in clogging of the waterfall and a voided warranty.

Performance Info

The units use 1.25 gallons of water per inch of waterfall per minute. Size the water pump accordingly.

Reference GPM when choosing the correct pumps to use.

Covers & Screen

Protective covers on the waterfall face and inlet shall not be removed until the waterfall is ready to run.

Failure to do so may cause permanent damage to the waterfall and void any warranty.

Each unit also comes with an optional screen that can snap into the water inlet for additional filtration if desired.

CMP does NOT recommend using the screen due to the buildup of hair or debris which can affect the performance of the waterfall.